We research and compare products using published specifications, features and owner feedback. When you buy through our links, we may earn a commission. As an Amazon Associate I earn from qualifying purchases. Learn more›

Can You Put Sorel Boot Liners in the Dryer? What Works and What Doesn’t

Can you put Sorel boot liners in the dryer? Learn when a tumble dryer is safe, the heat limits to watch, and safer drying methods for your liners.

Updated November 2026

You can put most Sorel boot liners in the dryer, but only on low heat and only if the label allows it. Tumble drying on low takes the liners from soaked to dry in a fraction of the time air drying needs, and it helps prevent the damp, musty smell that builds up after a long day on the mountain. The catch is heat. Too much of it can shrink the liner, pack down the insulation, or weaken the foam that gives the boot its shape.

Check the Liner Label First

Before anything goes in the machine, read the tag or the care instructions printed on the liner. Sorel and most other boot makers specify whether the liner is machine washable, whether it can be tumble dried, and the maximum heat setting. If the tag says air dry only or lists no dryer option, skip the dryer entirely. Liners with removable felt or foam footbeds are the most sensitive, because the footbed can warp or crack under direct heat.

Shopping for one? See our guide: 5 Best Boot Dryers with Ozone Options for Ski and Work Boots (2026).

How to Dry Sorel Liners in a Tumble Dryer

If the label permits tumble drying, follow these steps to protect the liner:

  1. Remove the liner from the boot and take out any removable footbeds or insoles.
  2. Shake off loose snow and dirt, then press out as much water as you can by hand. Do not wring the liner.
  3. Place the liner in the dryer with a couple of dry towels or a clean sneaker to help it tumble freely.
  4. Set the dryer to the lowest heat or the air-fluff setting. Run it in 20 to 30 minute cycles.
  5. Stop each cycle and check the liner. It should feel dry but not hot. Repeat until it is fully dry.

When to Skip the Dryer

Avoid the dryer if the liner has a foil layer, a heat-reflective coating, or a noticeably thin, stiff feel that suggests heat-sensitive materials. Also skip it if the liner has already started to separate at the seams. In these cases, air drying at room temperature is the safer choice.

Safer Ways to Dry Liners After Skiing

Air drying works well if you give it time and airflow. Stuff the liners with dry newspaper or a towel, which pulls moisture out of the foam, and swap the paper every few hours. Keep them out of direct sunlight and away from radiators, since sustained heat causes the same problems a hot dryer does. A dedicated boot dryer that uses warm, moving air at a controlled temperature is another option, and many ski shops stock them. Whatever method you choose, let the liners dry completely before the next day on the hill. Putting damp liners back in a boot leads to cold feet and a faster breakdown of the foam.

Common Mistakes

  • Using high heat because the liners feel damp. Low heat with patience works better.
  • Drying liners together with the shell or buckles still attached, which can scratch or warp parts.
  • Skipping the footbed removal step, so moisture stays trapped underneath.
  • Stopping too early. A liner that feels dry on the outside can still hold moisture deep in the foam.
  • Washing and drying in the same cycle without checking the label for detergent or temperature limits.

A mesh laundry bag helps keep small liner parts and footbeds together, so nothing gets lost or tangled in the drum. View on Amazon

Newspaper or unscented paper towels work well for absorbing moisture when you air dry, and they cost almost nothing to keep on hand. View on Amazon

A dedicated boot and shoe dryer offers a controlled alternative to the household dryer when you want heat without the risk. View on Amazon

FAQ

Can I put Sorel liners in a dryer on high heat?

No. High heat can shrink the liner, distort the footbed, and break down the foam. Use the lowest heat or air-fluff setting only.

How long does it take to dry Sorel liners in a dryer?

Drying usually takes several 20 to 30 minute cycles on low heat, depending on how wet the liners are. Check them between cycles and continue until they feel dry all the way through.

Is it better to air dry Sorel liners?

Air drying is gentler on the materials, but it takes longer. Use newspaper or towels to pull moisture out and keep the liners in a cool, ventilated spot.

Conclusion

Sorel liners can go in the dryer on low heat if the care label allows it and the liner has no heat-sensitive parts. Remove the footbeds, check the liners often, and stop as soon as they feel dry. When in doubt, air dry them slowly and keep them away from direct heat. If you have questions about a specific liner, the manufacturer’s care instructions are the final word.

Claire Whitaker

About Claire Whitaker

Claire Whitaker is part of our editorial team and reviews and edits our rocky mountain ski trips guides, checking product details against manufacturer specifications and owner feedback.

About the author

Claire Whitaker
Claire Whitaker

Claire Whitaker writes reviews and buying guides for Skiing The Rockies.